From the Routing and Remote Access management console, select Action | Configure and Enable Routing and Remote Access, or right-click the name of the server on which you want to enable RRAS and make the same selection from the console menu. Following the same basic procedure as in Exercise 7.01, begin by opening the Routing and Remote Access management console: Start | Administrative Tools | Routing and Remote Access.ģ. Uncheck the Expand Control Panel and Expand Network Connections check boxes, then click OK, and then OK again.Ģ. Select Classic Start Menu, and click the Customize button. ![]() To correct this, right-click an empty area of the taskbar, select Properties, and select the Start Menu tab. Instead, when you click Control Panel, you see another menu displaying the Control Panel items, and when you click Network Connections, you get yet another menu instead of the folder view. You might be unable to open the Network Connections folder as shown in Figure 7.17. After you've done this for both connections, we'll move to the main focus of this exercise and configure your VPN server for remote client access. To rename a network connection, select the connection to rename, click on File | Rename and type the new, more descriptive name for the connection, to simplify identification. For example, determine which network card is attached to the LAN and name it, aptly, "LAN." You might name the network connection that connects to the Internet "WAN" or "Internet" as shown in Figure 7.17.įigure 7.17 Renaming Your Network Connectionsġ. ![]() For convenience, it helps to properly name your network connections through the Network Connections folder so that they will be easy to identify. In this exercise, you will configure the Routing and Remote Access service to support various numbers of remote clients first through DHCP server address allocation, and then using IP address allocation direct from the VPN server.īefore we begin, make sure you have two network interfaces available to you.
0 Comments
Leave a Reply. |